Swarm drone light show software download, https://www.roppor.com
For more information on “Introduction to the swarm drone software platform, ROPPOR”, you can check out the video on the YouTube channel below.
Installation of ROPPOR Swarm Drone Remote Interlocking Software(SDAS)
1) Setting Preparation
There are basically three preparations described in the ROPPOR guide, and in order to use all functions including RTK, four preparations are required as follows.
(1) LTE Device & Companion Computer
(2) FC (Pixhawk)
(3) Operation PC, Relay PC
(4) RTK
This time, we will install SDAS, a software for drones and RTKs, on a Micro SD card in ROPPOR. The items required for SDAS installation and drone linkage in advance are as follows.
- Raspberry Pi 3A+ or 3B+
- 16GB Micro SD Memory Card 3.Quectel EC25 Mini PCle 4G/LTE Module
https://sixfab.com/product/quectel-ec25-mini-pcle-4glte-module/ 4.LTE Full Band PCB Antenna – u.FL Plug – 100mm
https://sixfab.com/product/lte-full-band-pcb-antenna-u-fl-plug-100mm/ 5.Sixfab Raspberry Pi 3G/4G<E Base HAT
https://sixfab.com/product/raspberry-pi-base-hat-3g-4g-lte-minipcie-cards/
In the case of Raspberry Pi, 3A was used, and in the case of 3B+, the USB port is free, so it is easy to expand in the future.